                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2991954
Imperial Industrial walk ways by theavatar111 is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

Just need a few extra walk ways for your Imperial facility? Print out some of these from Imperial Manufacturing Division XXI. Get from A to B without needing to go up or down those pesky ladders today!

In this thing is two variation of walk ways that may be compatible* with existing terrain systems (*yet to be tested - thanks nstephenh)

*Update 10/08/18
Added some connector piece that can be used to join the pieces together. Gets a little complicated as the holes on my curved pieces only on the short edges (both left and right), don't quite line up so had to make three different connector pieces.

4-1 is the "compatible" piece and the same dimensions as the official. I can be used to connect:
* any two official pieces together
* an official piece to the long top edge or shorter side edges of curved piece
* curved pieces long or side edges to another curved pieces curved or side edges

4-2 is Short edge to short edge
* Only for joining two short edges of printed curved pieces together

4-3 is Short to non-short
* Join the printed curved piece short edge to any official part  
* Join the printed curved piece's short edge to a long or side edge of another curved piece

Progress update (25/07/18):
Curved walk way part B - updated to fix bottom layer to be flat. Holes are reported as being too tight for offical connector parts. My test printed OK in this regard (round and hex are 4mm and pegs are about 3.5mm)

Curved A - new variation that should fit better and more detailed. Please print and let me know how it turns out.

Straight A - too loose into part B - needs rescaling and retesting

Straight B - needs reviewing

Compatible support columns will be posted soon.

Assembly - Print out parts A & B of your chosen walk way. Paint each part before gluing. They should just snap into together and may not really need gluing at all (to be tested)